Akasa All In One 2 Manual de Instalação descarregar pdf (Página 4)

2. Installing the panel inside a case

1 Remove the cover of an empty 5.25" external drive bay.

2 Insert all cables into the empty drive bay. Push the allinone

into the bay until it is ﬂush with the chassis front panel

3 Secure the allinone with screws or the case 5.25" mounting system

1 Connect the fan connector to the allinone fan cable.

Connect the other end of the fan cable to the fan header on the

motherboard (optional).

2 Connect temperature sensors to the allinone sensor cable. Use the

adhesive tape to secure them in the appropriate location.

NOTE : In auto mode Fan1,2 and 3 are controlled by Sensor 1,2 and 3

respectively. Please locate the sensors in the appropriate position.

WARNING: Do not place the sensor between the heatsink base

and the CPU.

3. Connecting the fans and temperature sensors

3 Connect the power cable to the PSU 4-pin molex connector.

1 2 3 4 5 6 7 8 9 ... 31 32

Sem comentários

Akasa All In One 2 Manual de Instalação Página 4